Specifications
DK440LX SPECIFICATION UPDATE
13
WORKAROUND: None.
STATUS: This erratum was fixed in BIOS revision 4D4KL0X0.86A.0014.P06.
5. Onboard SCSI Controller Identifies Tape Drive as Hard Drive
PROBLEM: The onboard SCSI controller may incorrectly identify an attached SCSI tape backup drive as a
hard disk drive.
IMPLICATION: The tape drive is not accessible, although it appears in the BIOS Setup Boot Menu.
WORKAROUND: None.
STATUS: This erratum was fixed in BIOS revision 4D4KL0X0.86A.0018.P09.
6. System Cannot Recover BIOS From LS-120 Drive
PROBLEM: The permanent system BIOS code stored in the boot block section of the BIOS flash memory
device does not include initialization code for the LS-120 drive.
IMPLICATION: If the system requires a BIOS recovery because the BIOS was corrupted during an update,
that BIOS recovery cannot be performed from an LS-120 drive. An attempt to recover the BIOS from an
LS-120 drive, using the BIOS recovery setting of the configuration jumper, will result in a media device error.
WORKAROUND: Temporarily replace the LS-120 drive with a standard diskette drive to perform the BIOS
recovery.
STATUS: This erratum will not be fixed.
7. SCO* UnixWare* Will Not Install From Onboard SCSI Channel B
PROBLEM: The SCSI driver for the SCO* UnixWare* operating system disables Channel B during installation
of the operating system. Unixware version 7.0 is not affected by this erratum.
IMPLICATION: An attempt to install from a SCSI device attached to onboard SCSI channel B will fail with the
error message: “Warning: adsl: Command timed out.”
WORKAROUND: None.
STATUS: This erratum will be fixed in a future revision of the SCSI driver.
8. Advanced Power Management May Suspend System During
CD-ROM Playback
PROBLEM: ATAPI devices (such as CD-ROM and DVD drives) do not reset the inactivity timer that is used
by Advanced Power Management to determine when to place the system into suspend mode.
IMPLICATION: When playback of an audio CD or a DVD file is the only system activity, the system will go into
suspend mode when the inactivity timer expires.
WORKAROUND: Temporarily disable the Low-power standby and Shut off monitor options on the Display
Properties, Screen Saver menu. This menu is available from the Windows* 95 Control Panel.
STATUS: This erratum will not be fixed.