Specifications

These errors may occur for the following reasons:
The hardware settings on the SCSI adapter card do not match
the configuration options selected during NETGEN. Check
your SCSI adapter card.
There is a hardware conflict between the SCSI adapter card and
another option card in the system. Check the port address,
DMA channel, and interrupt channel of other I/O cards in the
system. Some VGA cards and LAN cards use port address 330h,
which is the default for the SCSI adapter card.
The SCSI interface is not properly terminated. Make sure only
the devices on each end of the SCSI interface have
terminators. The terminators on all other SCSI devices should
be removed.
There is a SCSI ID conflict in the SCSI interface. Each device
must have a unique SCSI ID, from 0 to 7. Check the SCSI ID of
each device.
The SCSI adapter card is malfunctioning. Check to see if the
SCSI interface runs under MS-DOS. If so, the problem is with
the NetWare setup and not with the hardware. Check your
NetWare setup and configuration.
The SCSI hard disk drive does not work with the SCSI adapter
card. Again, check to see if the SCSI interface runs under
MS-DOS. If so, the problem is with the NetWare setup and
not with the hardware. Check your NetWare setup and
configuration.
Installing Software Drivers for NoveIl NetWare 286/386
6-31