Specifications

No SCSI logical drives to support
ASPIDISK did not find any logical drives to support. The driver
will not load and take up memory if this message appears.
There may be no logical drives to support for several reasons:
❏ There are no attached SCSI disk drives
❏ All SCSI disk drives are under control of the host adapter
BIOS
❏ The SCSI disk drives have not been partitioned yet.
Unable to open ASPI manager!
The ASPIDISK.SYS driver was unable to access the
ASPI4DOS.SYS driver. Make sure that the ASPI4DOS.SYS driver
is specified in your CONFIG.SYS file before the ASPIDISK.SYS
driver.
Unsupported (old-style) ASPI manager found
ASPIDISK v3.0 must be used with ASPI4DOS.SYS v3.0 or
newer. Older ASPI managers are not supported.
WARNING: Maximum number of logical drives
(A: to Z:) reached
The driver detected too many logical drives on the attached
SCSI drives. MS-DOS can support a maximum of 24 logical
hard disk drives (C: to Z:) in the system. You do not lose the
data on the logical drives; however, the data is not available
until a logical drive becomes available.
4-18 Installing Software Drivers for MS-DOS