Specifications

ASPIDlSK.SYS Messages
You may see the following error messages after attempting to
install ASPIDISK.SYS:
Command line arguments are incorrect
The DEVICE command line for the ASPIDISK.SYS driver is
incorrect. Make sure that the switches are specified correctly.
Error issuing SCSI inquiry command
ASPIDISK timed out on issuing a SCSI Inquiry command.
Check the SCSI bus termination, SCSI parity, and cabling.
The driver will not load if this message is displayed.
Failed to find any SCSI logical drives to support
The driver was unable to detect any logical drives on the
specified hard disk. Make sure that the hard disk is partitioned
and formatted.
Failed to read, or invalid, boot record
The driver was unable to read the disk parameters of the
specified hard disk. Make sure that the hard disk is partitioned
and formatted, and check the SCSI cable.
Invalid DOS version. DOS must be version 3.21
and above
The current version of MS-DOS is earlier than version 3.2. You
can load the ASPIDISK.SYS driver only on a system running
MS-DOS version 3.2 or later.
Installing Software Drivers for MS-DOS
4-17