Specifications

Modify your CONFIG.SYS file to include the DEVICE

commands for ASPI4DOS.SYS or ASPIEDOS.SYS and

ASPIDISK.SYS. Be sure to reserve logical partitions (/Rnn) if

necessary.

Reboot your computer. MS-DOS will install the ASPI4DOS.SYS

or ASPIEDOS.SYS driver but not the ASPIDISK.SYS driver.

Use the AFDISK program to partition the removable hard disk.

Reboot your computer. MS-DOS will install the ASPIDISK.SYS

driver.

Error

Messages

This section describes the error messages you may see when

you start your computer after installing the ASPI4DOS.SYS or

ASPIEDOS.SYS or ASPIDISK.SYS driver.

ASP14DOS.SYS or ASPIEDOS.SYS Messages

You may see the following error messages after attempting to

install ASPI4DOS.SYS or ASPIEDOS.SYS. The message displays the

name of the driver.

ASPI4DOS.SYS Installation Failed

MS-DOS was unable to load the ASP14DOS.SYS driver and

displays this message after one of the messages below to

indicate that the driver is not installed.

Slot #nn AHA-1740/1744 - Not configured for enhanced

mode

The ASPIEDOS.SYS driver is intended for the SCSI adapter card

when configured for enhanced mode. If the card is configured

for standard mode, ASPIEDOS.SYS will not load unless the /S

switch is specified. The /S switch is used with ASPIEDOS.SYS to

indicate which adapters are configured for enhanced mode.

4-14

Installing Software Drivers for MS-DOS