Specifications

You can include the following parameters and switches with the
DEVICE command for the ASPIDISK.SYS driver.
Parameters:
d:
Identifies the drive designator for the location of the
ASPIDISK.SYS file.
path
Identifies the directory path of the ASPIDISK.SYS file.
Include this parameter if you stored the ASPIDISKSYS
file in a directory other than the root directory.
Switches:
/D
Displays useful information about the SCSI adapter
during system startup.
/Rnn
Specifies the number of logical drives to reserve for a
removable hard disk; nn can be from 1 to 5. The default
is 1.
MS-DOS ignores this switch if the hard disk is
nonremovable.
The AFDISK Program
Use the AFDISK program to partition a SCSI hard disk that is not
installed under the BIOS of the SCSI adapter card.
AFDISK allows you to add or delete MS-DOS partitions on a SCSI
hard disk and to delete non-DOS partitions. The partitions you
create with AFDISK are compatible with MS-DOS partitions created
with FDISK (MS-DOS version 3.2 or later).
After partitioning a SCSI hard disk with AFDISK, you must install
the partitions using the ASPIDISK.SYS disk driver, as described
above.
Note
The ASPI MS-DOS Manager must already be installed in your
CONFIG.SYS file for AFDISK to run correctly.
Installing Software Drivers for
MS-DOS
4-9