Specifications

Parameters:
d: Identifies the drive designator for the location of the
ASPI4DOS.SYS or ASPIEDOS.SYS file.
path Identifies the directory path of the ASPI4DOS.SYS or
ASPIEDOS.SYS file. Include this parameter if you stored
the file in a directory other than the root directory.
Switches:
/Pnnn
Specifies the hexadecimal port address of the SCSI
adapter card. (Valid with ASPI4DOS.SYS only.) Valid
addresses are: 130, 134, 230, 234, 330, 334. The default
is /P330, which is the port address of the Epson SCSI
adapter card.
Only change the port address if you install more than
one SCSI adapter card in your system. In this case,
specify a port address other than /P330 for the SCSI
adapter which has a disabled BIOS.
/D
Displays useful information about the SCSI adapter
during system startup.
Enables support for SCSI logical unit numbers (LUNs)
other than zero (l-7). Omit this switch so the driver
recognizes only LUN 0 for each SCSI device.
/W
Enables virtual mode buffering for applications such as
Windows/386 version 2.x. (Valid with ASPI4DOS.SYS
only.) The driver attempts to allocate a 64KB virtual
buffer from extended memory. If no extended memory
is available, the driver allocates 64KB from conventional
memory.
Windows 3.0 does not require virtual mode buffering.
You can specify /W or /WM, described below, but not
both.
/WM
Enables virtual mode buffering using 64KB from
conventional memory. (Valid with ASPI4DOS.SYS only.)
Use /WM if your computer does not have extended
memory. You can specify /W or
/WM, but not both.
InstaIling Software Drivers far MS-DOS 4-5