Specifications

Normally, you do not need to alter the configuration settings.
The configuration program determines the settings based on
the SCSI devices you have installed.
3. When the settings for the SCSI adapter card are correct, you
can configure SCSI devices that you have connected to the
interface.Move to the
SCSI Device Configuration option
and press
Enter.
EISA SCSI Host Adapter options
The EISA SCSI Host Adapter screen looks similar to this:
- Epson EISA SCSI Host Adapter
Mass Storage device
Host Adapter Interface Mode...........Standard Mode. IRD 11
Standard Mode Resource Selection
I/O Port Definition..................I/O Port 330H (Standard Model
DMA Channel Definition. . . . . . . . . . . . . ..DMA 5 (Standard Mode)
Host Adapter BIOS.....................BIOS Base Address CCOOOH
Host Adapter SCSI ID..................Device Id 7
SCSI Bus Reset at Power-on. . . . . . . . . . ..Enable SCSI bus reset
SCSI Device Configuration.............Press <Enter> to set SCSI
Configuration Options
If you need to change a setting, use the arrow keys to move from
one setting to the next and press
Enter to make a selection. The
menu settings are described below.
Note
Normally, these settings are correct. You only need to change them if
you have installed an option card in your computer that conflicts with
these selections.
3-4
Configuring Your System