Specifications

Installing a SCSI hard disk drive
If you are installing an internal SCSI hard disk drive and you want
to boot from it, you must change the setting of jumper J3 on the
main system board to disable the built-in IDE hard disk drive
controller. This allows you to use the controller on your SCSI
adapter card. See your EISA Series User’s Guide for instructions on
changing the jumper setting.
Note
You must also use the System Configuration program described in
Chapter 3 to set any IDE hard disk drives as Not installed.
If you have a desktop computer, be sure to set the jumper while
you have the subassembly removed from the computer.
Note
The hard disk drive jumpers described in Chapter 6 of your EISA Series
User’s Guide are for IDE drives only. Your SCSI hard disk drive does not
contain these jumpers.
You also need to install the LED cable that came with your SCSI
adapter card. If you have a desktop computer, be sure to do this
while you have the subassembly removed from the computer.
To install the LED cable, follow these steps:
1. Locate the LED cable that came with the SCSI adapter card.
red wire
Setting Up the SCSI Interface 2-9