Specifications

Connecting the SCSI cable to the SCSI adapter card
Next you must connect the 50-pin, SCSI ribbon cable to the SCSI
adapter card. Follow these steps:
1. Carefully guide the ribbon cable over the processor board that
is connected to main system board in your EISA Series
computer. Keep the ribbon cable away from the ventilation
slots in the computer and away from possible electrical noise
sources or noise-sensitive components.
2. Locate the end of the 50-pin, SCSI ribbon cable. Notice pin 1
on the cable, which is designated by a red stripe.
3. Locate pin 1 on the SCSI adapter card’s internal SCSI
connector. Align pin 1 on the SCSI ribbon cable with pin 1 on
the internal SCSI connector.
4. Carefully insert the ribbon cable into the internal SCSI
connector. Press on both ends of the cable connector until it
is seated firmly in the SCSI connector.
Now you can replace the computer’s cover; see your EISA Series
User’s Guide for details. Make sure the SCSI ribbon cable does not
interfere with the cover or any other components.
2-8 Setting Up the SCSI Interface