Specifications

First install all internal devices and then all external devices. If you
plan to install only external SCSI devices, you can reinstall the
cover on your computer after you install the SCSI adapter card. See
your computer User’s Guide for instructions.
You must place any device containing a terminator that cannot be
removed at the end of the interface.
Note
Be sure to see the documentation that came with your SCSI device for
any information about
jumper settings, pin 1 orientation, the SCSI ID,
and terminators. Pin 1 orientation must be consistent throughout the
SCSI interface.
I Installing and Connecting an Internal Device
To connect an internal SCSI device, use the 50-pin, SCSI ribbon
cable that came with the SCSI adapter card. This cable has two
connectors for internal devices, If you plan to install more than
two internal SCSI devices, you need to purchase a special cable.
See your Epson dealer for details.
To install an internal SCSI device, you must perform these
procedures:
❏ Install the internal device in one of the drive bays inside the
computer.
❏ Attach the 50-pin, SCSI ribbon cable to the SCSI device.
❏ Connect the 50-pin, SCSI ribbon cable to the SCSI adapter
card.
These procedures are described in the sections below.
If you plan to install an internal SCSI hard disk drive in your
computer, see “Installing a SCSI hard disk drive” on page 2-9 for
additional instructions.
2-4
Setting Up the SCSI Interface