Specifications

To locate components on the card, refer to the following
illustration:
LED connector terminators
internal SCSI connector
EISA Series bus connector
The SCSI adapter card contains the following connectors and
sockets:
❏
❏
❏
❏
❏
Internal SCSI connector. Connect internal SCSI devices to the
adapter card using this connector.
External SCSI connector. Connect external SCSI devices to the
adapter card using this connector.
EISA Series bus connector. Connect the SCSI adapter card to an
EISA Series option card slot using this connector.
Terminators. Remove these if the SCSI adapter card is in the
middle of the daisy-chain arrangement of devices. Leave these
terminators installed if the SCSI adapter card is the first or last
device in the arrangement.
LED connector (J2). Connect the LED cable to this socket and
to your computer’s main system board when you install an
internal SCSI hard disk drive.
Note
Jumper J3 controls the terminator power supply and J5 controls the
diagnostic functions of the adapter card. Do not alter these jumper
settings.
2-2 Setting Up the SCSI Interface