Specifications

❏ Support for the common, single-ended SCSI interface
❏ Device driver support for MS-DOS? OS/2, UNIX,® and Novell®
NetWare® 286/386.
How to Use This Manual
This manual explains how to install and configure your SCSI
adapter card. It also describes attaching optional SCSI devices and
installing drivers for the most common operating systems.
If you are not familiar with the SCSI interface, be sure to read
Chapter 1 for an introduction to SCSI. Follow the instructions in
Chapters 2 and 3 for setting up the SCSI interface and configuring
your computer for use with SCSI. Then see Chapter 4, 5, 6, or 7 to
install the necessary drivers for your operating system.
The following chapter summaries show you where to look for
specific information:
Chapter 1 introduces you to the SCSI interface.
Chapter 2 provides instructions for installing the SCSI adapter
card and your SCSI devices.
Chapter 3 describes how to configure your EISA computer to
operate with the SCSI devices you install.
Chapter 4 describes how to install the drivers for MS-DOS.
Chapter 5 describes how to install the drivers for OS/2.
Chapter 6 describes how to install the drivers for Novell NetWare.
Chapter 7 describes how to install the drivers for UNIX.
You’ll also find an index at the back of the manual.
2 Introduction