Technical data

sd(7D) Devices SunOS 5.5
ENXIO During opening, the device did not exist.
EROFS The device is a read-only device.
CONFIGURATION
Driver Configuration The sd driver can be configured by defining properties in sd.conf file. Following are the
supported properties:
qfull-retries The supplied value is passed as the qfull-retries capability value
of the HBA driver. See scsi_ifsetcap(9F) for details.
qfull-retry-interval The supplied value is passed as the qfull-retry-interval capability
value of the HBA driver. See scsi_ifsetcap(9F) for details.
FILES sd.conf driver configuration file
/dev/dsk/cntndnsn block files
/dev/rdsk/cntndnsn raw files
where:
cn controller n
tn SCSI target id n (0-6)
dn SCSI LUN n (0-7)
sn partition n (0-7)
SEE ALSO format(1M), close(2), ioctl(2), lseek(2), read(2), write(2), driver.conf(4), cdio(7I),
dkio(7I), esp(7D), isp(7D), scsi_ifsetcap(9F)
ANSI Small Computer System Interface-2 (SCSI-2)
Emulex MD21 Disk Controller Programmer Reference Manual
DIAGNOSTICS Error for command ’<command name>’Error Level: Fatal
Requested Block <n>, Error Block: <m>
Sense Key: <sense key name>
Vendor ’<vendor name>’: ASC = 0x<a> (<ASC name>), ASCQ = 0x<b>, FRU = 0x<c>
The command indicated by <command name> failed. The Requested Block is
the block where the transfer started and the Error Block is the block that
caused the error. Sense Key, ASC, and ASCQ information is returned by the
target in response to a request sense command.
Caddy not inserted in drive
The drive is not ready because no caddy has been inserted.
Check Condition on REQUEST SENSE
A REQUEST SENSE cmd completed with a check condition. The original
command will be retried a number of times.
Label says <m> blocks Drive says <n> blocks
There is a discrepancy between the label and what the drive returned on the
READ CAPACITY command.
7D-286 modified 30 Aug 1995