Technical data

SunOS 5.5 Devices esp(7D)
SCSI bus DATA IN phase parity error
The driver detected parity errors on the SCSI bus.
SCSI bus MESSAGE IN phase parity error
The driver detected parity errors on the SCSI bus.
SCSI bus STATUS phase parity error
The driver detected parity errors on the SCSI bus.
Premature end of extended message
An extended SCSI bus message did not complete. Suspect a target f/w problem.
Premature end of input message
A multibyte input message was truncated. Suspect a target f/w problem.
Input message botch
The driver is confused about messages coming from the target.
Extended message <n> is too long
The extended message send by the target is longer than expected.
<name> message <n> from Target <m> garbled
Target <m> send message <name> of value <n> which the driver did not under-
stand.
Target <n> rejects our message <name>
Target <n> rejected a message send by the driver.
Rejecting message <name> from Target <n>
The driver rejected a message received from target <n>
Cmd dma error
The driver was unable to send out command bytes.
Target <n> refused message resend
The target did not accept a message resend.
Two byte message <name> <value> rejected
The driver does not accept this two byte message.
Unexpected Selection Attempt
An attempt was made to select this host adapter by another initiator.
Polled cmd failed (target busy)
A polled cmd failed because the target did not complete outstanding commands
within a reasonable time.
Polled cmd failed
A polled command failed because of timeouts or bus errors.
Disconnected command timeout for Target <id>.<lun>
A timeout occurred while target/lun was disconnected. This is usually a target
f/w problem. For tagged queuing targets, <n> commands were outstanding
when the timeout was detected.
Disconnected tagged cmds (<n>) timeout for Target <id>.<lun>
A timeout occurred while target/lun was disconnected. This is usually a target
modified 30 Aug 1995 7D-107