Installation guide

Insert the AFW-4300 into the PCI expansion slot. Press down

firmly until the card clicks into place; then replace the slot cover

screw. When installed properly, the card should appear level with

the expansion slot, as shown below.

Once the AFW-4300 is installed in your system complete the

following steps.

Windows Installation

After physically installing the card into the PCI slot and replacing

the slot cover screw, replace the cover on your computer and then

reattach the power cord. Once this is done, power up the

computer.

During the operating system startup, the card will automatically

be detected and Windows will load an embedded driver for the

card. If your system prompts you to restart the computer, do so.

STEP 4

Depending on the tightness of the PCI slot,

considerable force might be required to insert the card.

NOTE

COMPLETING THE INSTALLATION

STEP 1

STEP 2

1394IG.fm Page 3 Thursday, November 9, 2000 8:55 AM