Installation guide

PROBLEM: 'Won't Format" - "System Won't Recognize" -
"Can't Access"
SOLUTION:
A Has drive been initialized? now level format,
partitioned. high level format)
B. --Check --for--properdrive--setect.--
C. Check ribbon cables at controller for proper
pin one (1) alignment.
D. Verify that the 20 pin ribbon cable is connected
to the correct port on the controller card.
E. If two hard drives in system, verify proper
termination. (The terminating reSistor must be
removed from all but the last physical hard drive
in the chain)
F. Check for proper installation of the controller card
in the expansion slot.
G. Replace controller card.
TECHNICAL SUPPORT AVAILABLE AT 1 [phone]
5