Installation guide

I. Low Level Fonnat (Western Digital)
A Insert MS DOS 3.3 diskette into A: drive.
B. Cold or warm boot system.
C. Remove MS DOS 3.3 diskette from A: drive.
D __ ~~_~ Insert MS DOS 3.3 "Utility" diskette into A: drive.
E.
1. Enter DEBUG CR
2. At DEBUG prompt (-), enter: G=C800:5 CR
Screen will display:
1. SUPER BIOS FORMATIER
2. CURRENT DRIVE IS C:, SELECT NEW DRIVE OR CR
3.
4.
5.
6.
FOR CURRENT.
CURRENT
INTERLEAVE IS 3, SELECT NEW
INTERLEAVE OR CR FOR CURRENT.
ARE YOU DYNAMICALLY CONFIGURING THE DRIVE
-ANSWERYjN
A. ENTER YCR
B. KEY IN DISK CHARACTERISTICS __ _
CYLINDERS, HEADS, ETC. CR
ARE YOU VIRrUALLY CONFIGURING THE DRIVE -
ANSWERYjN
A NOTE: ENTER Y CR IF YOU WANT A C:
PARTITION SMALLER THAN THE MAXIMUM
SIZE ALLOWED FOR A DOS PARTII10N.
ENTER N CR IF YOU WANT A C: PARTITION
THE MAXIMUM SIZE ALLOWED FOR A DOS
PARTITION.
PRESS Y TO BEGIN FORMATIING DRIVE C WITH
INTERLEAVE 03.
A ENTER YCR
NOTE: Low level format should take apprOximately 10-20 minutes to
complete.
II. FDISK and DOS format (if you answered "N" for virtually
configuring) .
A Remove MS DOS 3.3 utility diskette from A drive.
B. Insert MS DOS 3.3 diskette into A drive.
C. Press any key to reboot system.
D. A: Enter FDISK CR
E. Screen will display:
1. FDISK OPTIONS
2. CURRENT FIXED DISK DRIVE: 1
3. CHOOSE ONE OF THE FOLLOWING:
4. ENTER CHOICE: (1) CR (CREATE DOS PARTITION)
F.
Screen will now display:
1. CREATE DOS PARTITION
2. CURRENT FIXED DISK DRIVE: 1
3. ENTER CHOICE: (1) CR (CREATE PRlMARY DOS
PARTITION)
G. Screen will now display:
39