Installation guide

MINISCRIBE CORPORATION
INSTALLATION GUIDE
FOR MINISCRIBE MODEL
3053
This gUide will allow you to install a MiniScribe hard disk drive into your
IBM PC XI' / AT or clone system.
1. Set the drive on a padded surface (anti-static if available). with the
printed circuit board facing up.
2. If your system requires the use of mounting rails to secure the drives.
attach them in the orientation that best fits your system.
3. Setting the drives select switCh:
v
34 Pin Ribbon Cable (TwIsted)
F1GUREl
DRIVE SPECIFICATIONS
Formatted Capacity -44.6 MBytes
Data Cylinder -1024
Read/Write Heads -5
Average Access Time -25msec
(Based on a 6 microsec step rate)
Power Dissipation -12.4 Watts Average
Write Precompensation Cyl -512
Starting Reduce Write -1024
Current Cylinder
8
DRIVE SELECT JUMPERS
RP14
Attach 20 pin ribbon cable to J2.
Attach 34 pin ribbon cable to J 1.
Attach power connector to J3.
F1GURE 2.
POWER CONNE