Specifications

Adaptec Fibre Card 9210LP User’s Reference

Verifying the Adapter

You can verify the adapter and cable installation by powering up the

system and looking at the two LEDs on the bulkhead of the adapter.

See Figure 6 on page 10. Under normal operation, the LEDs operate

as follows:

Upon Power-up

■ PWR/ACT LED is on

■ LNK LED is off

During Card Initialization by the Host OS

■ PWR/ACT LED will flash as Fibre Channel devices are

identified

■ LNK LED is off

Once the Card has been Initialized by the Host OS

■ PWR/ACT LED will flash at approximately one second

intervals

■ LNK LED is on if the adapter is operating properly

Figure 6. Adaptec Fibre Card 9210LP and Adaptec Fibre Card 9210LPC

With Low Profile and Standard Height Brackets