Specifications

7
Installing the Hardware
WARNING: Be careful when inserting the Adaptec Fibre Card
9210LP into a PCI slot. Some older 32-bit slots do not
accomodate 64-bit cards, and the card or slot may break if
you use force.
Figure 3. Installing the Adapter
7 Replace the slot cover screw.
Changing the Bracket on Your Adapter
Your Adaptec Fibre Card 9210LP comes with a low profile bracket. If
you need to attach a standard height bracket, follow these steps:
1 Unscrew the two screws located on the face of your Fibre
Channel adapter near your bracket. Set the screws aside.
2 Remove the bracket.
3 Attach the new bracket by lining up the bracket mounting tabs
with the matching holes in your Fibre Channel adapter. Fasten
Vertical Installation
Horizontal Installation