Datasheet

B-9
DOS Utilities
Example
A:\> AFU UPDATE /C 0
Adaptec Flash Utility V4.0-0 B5749
(c)Adaptec Inc. 1999–2002. All Rights Reserved.
Updating Controller 0 (Adaptec 2410)
Reading flash image file (Build 5749)
AFU is about to update firmware on controllers Adaptec 2410
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE***
This might take a few minutes.
Writing Adaptec 2410 (4MB) Flash Image to controller 0...OK.
Verifying...OK
Please restart the computer to allow firmware changes to take
effect.
VERIFY
The
VERIFY command compares the contents of each of the
flash components on a controller to the corresponding image in
a UFI file and indicates whether they match. Use this command
to determine whether a controller’s flash components are up-to-
date when compared to a specific UFI file.
After using the
VERIFY command, you must restart the
computer upon completion of this command.
Default Switch Values
If you do not include the /C switch, the AFU returns a fatal error
message.
If you do not include the
/D switch, the AFU verifies against
UFI files in the current default drive and directory.
Example
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V4.0-0 B5749
(c)Adaptec Inc. 1999–2002. All Rights Reserved.
Reading flash image file (Build 5748)
Controller #0: Adaptec 2410
ROM: Checksum: 797B [VALID] (Build 5748)
File: Checksum: 797B [VALID] (Build 5748)
Image Compares Correctly
VERSION
The
VERSION command displays version information about the
flash components on a controller.
Use the
/C switch to get version information about a specific
controller or multiple controllers.