Datasheet

2-1
2
Installing the Controller
In this Chapter...
Overview
To install the controller and drives, all you need is up to four of
each of the following:
■ Serial ATA hard disk drives
■ Serial ATA cables (supplied in this kit)
Configuration of Serial ATA devices is simple for the following
reasons:
■ There are no jumpers or switches to set on the controller or hard
drives.
■ The interface cable ends are identical, so you don’t need to
worry about which end to attach to the controller and which
end to the drive.
■ All interface connectors are keyed so that you can insert them in
only one direction.
Overview 2-1
Installing the Controller 2-2
Checking Your Controller and Devices 2-3
Determining the Boot Controller 2-3