User`s guide

Chapter 8: Installing the Driver on an Existing Operating System ● 57
Installing on OpenServer
To install the driver on OpenServer:
1 Start your computer, then insert the driver disk.
2 Begin the driver package installer:
pkgadd -d diskette1
3 At the installer prompt, type go .
4 Select 1 for the aacraid package.
5 When the installation is complete, select q to quit the installer.
6 Reboot your computer and remove the driver disk.
7 Continue with Managing Your Storage Space on page 59.
Installing on UnixWare
To install the driver on UnixWare:
1 Start your computer, then insert the driver disk.
2 Begin the driver package installer:
pkgadd -d diskette1
3 At the installer prompt, type go .
4 Select 1 for the aacraid package.
5 When the installation is complete, select q to quit the installer.
6 Reboot your computer and remove the driver disk.
7 Continue with Managing Your Storage Space on page 59.
Installing on Solaris
To install the driver on Solaris:
1 Start your computer.
2 Check for any pre-existing Adaptec driver by performing a pkginfo SUNWaac in a terminal
window. If there is no pre-existing Adaptec driver on your computer, continue with Step 3.
If an Adaptec driver is already installed on your computer, perform a
pkgrm SUNWaac to
remove it.
Caution:
If your operating system currently boots from the Adaptec controller, do not
reset your computer after you remove the pre-existing Adaptec driver. Instead, follow
the steps in this section to install a new driver before rebooting your computer.
3
Insert and mount the driver disk:
volcheck
4 Change to the driver installer directory:
cd /floppy/floppy0/DU/sol_210/i86pc/Tools
!