User`s guide

Appendix C: Using the Adaptec RAID Controller Utility ● 95
Using the -Select Utility to Modify Controller
Settings
Included in the Adaptec RAID Controller utility is a tool for modifying
the settings of your controller and the disk drives connected to it. This
utility is called SASSelect, SATASelect, or SCSISelect, depending on what
type of controller you have.
Opening a -Select Utility
To open a -Select utility, start the Adaptec RAID Controller utility (see
page 91), select the -Select utility, then press Enter.
Follow the on-screen instructions to modify the settings of your
controller and connected disk drives as required.
Applying Changes and Exiting
1 To exit a -Select utility, press Esc until you are prompted to exit.
If you modified any settings, you are prompted to save the changes
before you exit.
2 Select Yes to exit, then press any key to restart your computer.
Any changes you made take effect after the computer restarts.
Modifying Your Controller’s Configuration
Note: Default controller settings are suitable for most computers.
Adaptec recommends that you do not change the default setting.
To modify your controller’s settings, select Controller Configuration
from the main -Select utility menu.
The table on page 96 lists controller configuration options. Some
options may not be available for your controller. Additional, controller-
specific options are also available:
● For SAS controller-specific settings, see page 97.
● For SATA controller-specific settings, see page 97.
● For SCSI controller-specific settings, see page 98.