User`s guide

Chapter 6: Creating a Bootable Array ● 46
9 When the Array Properties screen opens, follow the instructions in
the table below:
10 When a cache warning message displays, type Y.
11 Once the array is created, a message displays telling you that the
array can now be used. Press any key to return to the ACU Menu.
You can start using the array immediately. However, performance is
reduced until the build process is complete.
12 Press Esc until the Exit Utility window appears.
13 Select Yes, then press Enter.
The computer restarts.
14 Continue with Making Your Array Bootable on page 49.
Property Line Entry or Selection
Array Type Select RAID 5, then press Enter.
Array Label Type a name, then press Enter.
Array Size Press Enter, then press Enter again to use the default
granularity of GB.
Stripe Size Press Enter to use the default (256KB).
Read Caching Press Enter to use the default (Yes).
Write Caching Press Enter to use the default (Enable always).
Create RAID via Press Enter to use the default (Build/Verify).
[Done] Press Enter.