User`s guide

Appendix E: Using the Adaptec Flash Utility ● 121
Update
Updates the flash components of one or more RAID controllers on your
computer from the flash image data in a UFI file. You must restart the
computer following an update command.
The command syntax for the update command is:
AFU UPDATE [/C<Controller ID>] [/D <UFI File Path>]
You can also use the /C and /D switches (see Save on page 120).
This example shows a typical system response after an update.
A:\> AFU UPDATE /C 0
Adaptec Flash Utility V4.0-0 B5749
(c)
Adaptec Inc. 1999–2005. All Rights Reserved.
Updating Controller 0 (
Adaptec 2820)
Reading flash image file (Build 5749)
AFU is about to update firmware on controllers Adaptec Adaptec
2230SLP
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE***
This might take a few minutes.
Writing
Adaptec Adaptec 2230SLP (4MB) Flash Image to controller
0...OK. Verifying...OK
Please restart the computer to allow firmware changes to take
effect.
Verify
Compares the contents of each of the flash components on a RAID
controller to the corresponding image in a UFI file, and indicates
whether they match. After using the verify command, you must restart
the computer.
The command syntax for the VERIFY command is as follows:
AFU VERIFY [/C<Controller ID>] [/D <UFI File Path>]
You can also use the /C and /D switches. See Save on page 120 for more
information.