Installation guide

U41255-J-Z156-1-76 1
Introduction
This installation guide provides you with the information and procedures you
need to install, configure, and test Hardware for Cluster Services running
Microsoft Windows® 2000 Advanced Server on Primergy Servers with Adaptec
3200S two channel SCSI RAID Controllers and PRIMERGY S30 storage
subsystem. This guide contains configuration and installation information only.
This document describes the steps involved in installing and configuring
PRIMERGY Servers with the 3200S RAID controllers and the PRIMERGY S30
Storage Subsystem.
The guide details the steps involved in
● setting-up the controllers prior to installation in the servers,
● installing the controllers,
● setting up the RAID array on the controllers on each node,
● setting up the PRIMERGY S30 storage subsystem.
Users of this guide should be familiar with the operation and setup of a server
cluster system and with the operation of Adaptec RAID controllers. This guide
will not attempt to cover cluster operation except as specifically related to instal-
lation, configuration, and operation of the storage subsystem as implemented
using the components described. If the reader is in need of more specific infor-
mation about cluster setup or operation, or the use of hardware or software,
please refer to the appropriate documentation available separately. The last
page of this guide may help in locating some of this other information.