Installation guide

20 U41255-J-Z156-1-76
Power Sequencing Installation
Ê Configure all HDDs to the appropriate the RAID level for the cluster (shared
SCSI-BUS).
ATTENTION!
Wait until the build is finished for all RAIDs.
Ê Enable the Cluster support (repeat step3).
ATTENTION!
Is the cluster support enabled you cannot change the RAID configu-
ration.
Ê Boot the Operating system NT Enterprise Edition 4.0 SP6 or W2K Advanced
Server on Node 1 and partition the ”shared disks” (W2K basic disks).
Ê Install MSCS on Node 1 > (the RAID build starts).
Ê Boot Node 2 and install MSCS.
Power Sequencing for Cluster Installation
Step Node
1
Node
2
Storage Comments
Setting Up
Networks
On On Off Verify that all storage devices on the
shared bus are powered off. Power
on all nodes.
Setting Up
Shared Disks
On Off On Shutdown all nodes. Power on the
shared storage, then power on the
first node.
Verifying Disk
Configuration
Off On On Shutdown first node, power on the
second node. Repeat for nodes 3
and 4 if necessary.
Configuring the
First Node
On Off On Shutdown all nodes; power on the
first node.
Configuring the
Second Node
On On On Power on the second node after the
first node was successfully
configured. Repeat for nodes 3 and 4
if necessary.
Post-Installation On On On At this point all nodes should be on.
Power Sequencing for Cluster Installation
!
!