Specifications

Configuring the Hardware and Installing Windows NT 51
5. Select choice 2. Update drives attached to a single ServeRAID or
ServeRAID II Adapter if only one ServeRAID adapter is installed in your
system and choice 3.3. Update drives when there are 2 ServeRAID II
Adapters installed for two ServeRAID adapters.
Note: If there are three or four ServeRAID adapters installed in the system
then execute the following procedure:
a. When the system boots and asks which adapter to use, select choice 2.
Update drives attached to a single ServeRAID or ServeRAID II
Adapter.
When you see the question
Would you like to proceed (Y/N)?, answer N.
a. At the A:> prompt, if there are three ServeRAID II adapters installed, type
in
3serv and with four ServeRAID adapters installed type in 4serv and press
Enter.
6. Follow the instructions that appear on the screen.
7. When this update is complete, power cycle the server and any SCSI external
expansion units.
2.11 Configurating the Advanced System Management Adapter
The Advanced System Management Adapter (ASMA) is an ISA card and you
must determine which system resources are used by it. For that purpose you
must run the ASMA configuration utility. These resources must be made known to
the system with the Netfinity 7000 System Configuration Utility (SCU).
As the Advanced System Management Adapter is standard in the Netfinity 7000,
the card is already configured. But we recommend that you check the settings to
avoid conflicts with additional adapter cards installed and ensure that the adapter
properly works.
1. Insert the ASMA configuration update utility and device driver diskette in the
floppy disk drive. The utility program writes an SM.INI file to the diskette. This
file is used during the device driver installation in Windows NT. Make sure the
diskette in the floppy disk drive is not write protected.
2. Reboot your system.
3. The utility is automatically loaded from the diskette.
1. Update drives attached to the PCI Adaptec SCSI Controllers
2. Update drives attached to a single ServeRAID or ServeRAID II Adapter
3. Update drives when there are 2 ServeRAID II Adapters installed
4. Update drives attached to the IBM F/W PCI-Bus RAID Adapter
5. Update drives attached to the IBM F/W Streaming RAID (Micro Channel)
6. Check drives attached to the 704 Mylex PL Raid Adapter
Enter a choice: