Specifications

Configuring the Hardware and Installing Windows NT 43
Figure 13. EXP10 Bay SCSI ID Assignments
The EXP10 already integrates a SCSI signal repeater to support Wide Ultra SCSI
mode with external cable lengths up to 2 meters. Figure 14 shows the rear of the
EXP10.
To configure a Netfinity EXP10 as a single 10 drive SCSI channel, one external
SCSI cable is attached from the SCSI adapter to the SCSI bus 1 IN connector in
the unit. The 0.4 meter internal cable provided in the ship group is connected to
the SCSI bus 1 OUT and the SCSI bus 2 IN connectors of the unit. The external
terminator is then installed on the SCSI bus 2 OUT.
When configuring a Netfinity EXP10 with both buses independent of each other,
one external SCSI cable is attached from the SCSI adapter to the SCSI bus 1 IN
connector on the unit. A second external SCSI cable is attached from another
SCSI adapter connector in the same or a different server to the SCSI bus 2 IN
connector in the unit. The SCSI bus 1 OUT and the SCSI bus 2 OUT connectors
must have an external SCSI terminator attached. The Netfinity EXP10 ships with
one terminator, so another terminator (part #32G3918) must be ordered to
support this configuration.