User`s guide

3-8

PowerDomain 2940UW/3940UW User’s Guide

Stock Number: 510864-00, Rev. B Page: 3-8

Print Spec Number: 493742-00

Current Date: 2/20/96 ECN Date: 2/27/96

PowerDomain 2940UW Termination

Termination is initially set to Automatic on the PowerDomain 2940UW

accelerator card. If you are using only one internal SCSI connector or

only the external SCSI connector, you do not need to change this setting.

In case your particular SCSI device does not respond appropriately

to the Automatic setting, refer to the following table to determine

which termination setting you should use:

Devices Connected to the

PowerDomain 2940UW

Termination

External (68-pin) connector only Enabled

Internal (50-pin) connector only Enabled

Internal (68-pin) connector only Enabled

Internal (50- and 68-pin) connectors Wide-to-narrow

Internal (50-pin) and 68-pin external

connectors

Wide-to-narrow

Internal (68-pin) and external (68-pin)

connectors with 68-to-68-pin cable

Disabled

External (68-pin) and internal (68-pin)

connectors with 68-to-50-pin cable

Wide-to-narrow