User`s guide

iii
PowerDomain 2940UW/3940UW User’s Guide
Stock Number: 510864-00, Rev. B Page: iii
Print Spec Number: 493742-00
Current Date: 2/20/96 ECN Date: 2/27/96
– The Adaptec Interactive Fax system provides product literature, answers to
commonly asked questions, and current information about Adaptec
products and services. The Adaptec Interactive Fax system is available
23 hours a day, 7 days a week. The Fax system is out of service 1 hour each
day. You can call this service directly at 408-957-7150.
■ For sales information, call 800-959-SCSI (7274) or 408-945-2550, Monday
through Friday, 6:00
A.M. to 5:00 P.M., Pacific Time.
■ To order Adaptec software and cables, call 800-442-SCSI (7274) or
408-957-SCSI (7274), Monday through Friday, 6:00
A.M. to 5:00 P.M., Pacific
Time.
■ To request additional documentation for Adaptec products, call 800-934-2766
or 510-732-3829, Monday through Friday, 6:00
A.M. to 5:00 P.M., Pacific Time.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses, and
can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television equipment reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Move the equipment away from the receiver
• Plug the equipment into an outlet on a circuit different from that to which the receiver is
powered
• If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions
CAUTION: Only equipment certified to comply with Class B (computer input/output devices,
terminals, printers, etc.) should be attached to this equipment, and must have shielded interface
cables.
Finally, any changes or modifications to the equipment by the user not expressly approved by
the grantee or manufacturer could void the user’s authority to operate such equipment.
Each PowerDomain 2940UW/3940UW is equipped with an FCC compliance label which shows
only the FCC identification number. The full text of the associated label follows:
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept
any interference received, including interference that may cause undesired operation.