Instruction manual

8
SCSI Card 2940UW Pro User’s Reference
“Attention! Too many devices are terminated on a 68-pin (wide)
connector of your AHA-2940UW Pro. Consult documentation. Press
any key to continue.”
The SCSI Card BIOS has detected that more than two devices have
been terminated on the wide SCSI segment.
■
Verify the termination on both internal and external wide
(68-pin) connectors. Terminate only the last SCSI device at the
far end of each cable. The SCSI devices between the ends of
each cable must have their terminators removed (or disabled).
See
Cabling Examples
on page 22.
“Attention! Insufficient termination detected on a 68-pin (wide)
connector of your AHA-2940UW Pro. Consult documentation. Press
any key to continue.”
The SCSI Card BIOS has detected that either only one or no devices
have been terminated on the wide SCSI segment.
■
Verify the termination on both internal and external wide
(68-pin) connectors. Terminate the SCSI device at the end of
each cable. The SCSI devices between the ends of each cable
must have their terminators removed (or disabled). See
Cabling
Examples
on page 22.
“Attention! Too many devices are terminated on the 50-pin (narrow)
connector of your AHA-2940UW Pro. Consult documentation. Press
any key to continue.”
The SCSI Card BIOS has detected that more than two devices have
been terminated on the wide SCSI segment.
■
Verify the termination on the internal narrow (50-pins)
connector. Terminate only the last SCSI device at the end of the
cable. The SCSI devices between the end of the cable and the
host adapter must have their terminators removed (or
disabled). See
Cabling Examples
on page 22.
“Attention! Insufficient termination detected on a 50-pin (narrow)
connector of your AHA-2940UW Pro. Consult documentation. Press
any key to continue.”
The SCSI Card BIOS has detected that either only one or no devices
have been terminated on the wide SCSI segment.
■
Verify the termination on the internal narrow (50-pins)
connector. Terminate the SCSI device at the end of the cable.
The SCSI devices between the end of the cable and the host
adapter must have their terminators removed (or disabled).
See
Cabling Examples
on page 22.