User`s guide

3-4
AHA-2940UW/OF and AHA-2944UW/OF User’s Guide
environment of the other devices, the utility must make
assumptions for configuration settings based on the active
device.
To select a device
■
Press
↑
,
↓
, or Space to scroll among the list of devices.
■
When the device you want to configure appears at the
Select Host Adapter to Configure prompt, press Enter.
The top portion of the configuration screen (Host Adapter
SCSI ID and above) for the selected device appears. The
remaining options are displayed line-by-line as you set each
parameter.
Figure 3-3 shows the complete configuration screen for the
selected device.
--------------[AHA-294XU/UW/D - Bus 1 - Device 4]--------------
Host Adapter SCSI ID .......................... [ 7 ] (default)
{<Space> to select settings <Tab> to select device }
{<Enter> to accept setting <Esc> to abort configuration }
{!=select default setting F6=restore all default settings }
{@=select saved setting F7=restore all saved settings }
{#=select previous setting F8=restore all previous settings }
Maximum Sync Transfer Rate - SCSI ID [ 0] [ 40.0 ] (default)
Enable Disconnection ------- SCSI ID [ 0] [ YES ] (default)
*
Do you wish to save your settings? .... [ YES ] ..settings saved
Do you wish to reboot the system? ..... [ NO ]
Do you wish to reinitialize the device? [ YES ] . device reinitialized
SCSI Parity Checking ..................... [ ENABLED ] (default)
Host Adapter SCSI Termination ............ [ AUTOMATIC ] (default)
Initiate Sync Negotiation -- SCSI ID [ 0] [ YES ] (default)
Initiate Wide Negotiation -- SCSI ID [ 0] [ YES ] (default)
Reset SCSI Bus at Host Adapter Initialization [ YES ] (default)
Figure 3-3. Device Configuration Screen
Support for Ultra SCSI Speed.............. [ ENABLED ] (default)