Specifications

Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices.
2. Disconnect all external cables and power cords; then, remove the side cover.
See “Removing the side cover” on page 52.
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, be certain it does not interfere with other cables
connected to the computer.
Rope clip
6. If you have other options to install or remove, do so now; otherwise, replace the
side cover (see “Replacing the side cover”).
7. Reconnect the external cables and power cords. Turn on the attached devices,
and turn on the computer.
Replacing the side cover
If you removed the support bracket, reinstall it before you replace the side cover.
See “Removing and installing the support bracket” on page 53.
Note: The rear adapter retaining bracket rests against the computer side cover.
You might find it easier to lay the computer on its side to replace the side
cover.
Installing options 67