User`s guide

8
Connecting Internal SCSI Devices
5 Connect one end of the internal SCSI cable to the PowerDomain 2930
internal SCSI connector, as shown in the next figure.
To connect more than two internal SCSI devices, you will need
an internal SCSI cable with enough connectors for all devices.
6 Connect the other end of the cable to the last internal SCSI
device, as shown in the next figure. This SCSI device must be
terminated. (See Step 5 on page 11.)
Make sure Pin 1 on the cable aligns with Pin 1 of the internal
SCSI device connector. Pin 1 is usually designated by a “1” or
small triangle.
Blue or red stripe
denotes Pin 1
Standard 50-pin
internal SCSI cable
(included in kit)
Pin 1 marking
Key
Internal SCSI
connector
Terminated internal
SCSI device
Internal SCSI cable