Instruction manual

11
Using the SCSI Card 2930U2 and SCSI Peripherals
Ultra2 (LVD) Hard Disk Drives
■ We recommend keeping your Ultra2 hard disk drives separate
from your non Ultra2 peripherals. Connecting a non Ultra2
hard disk drive to the Ultra2 connector on the SCSI Card
2930U2 causes the Ultra2 SCSI segment of the SCSI bus to drop
down to Ultra SCSI performance levels (40 MBytes/sec).
■ Do not connect your Ultra2 hard disk drives to connectors
other than the Ultra2 connector on the SCSI Card 2930U2.
■ Internal Ultra2 SCSI peripherals come from the factory with
termination disabled and cannot be changed. Proper termina-
tion is provided by the built-in terminator at the end of the
Ultra2 internal SCSI cable provided in the kit.
Scanners
■ You will need to install the scanner manufacturer’s proprietary
software drivers. See your scanner’s documentation for
details.
Ultra2 Internal Connector
Figure 1. Ultra2 Internal Connector