Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 81
Servicing Instructions 227 436 37 Rev. B V1.3
- Thermal printer AR200 prints 10mm-plateau or 10mm-gap(25mm/s)
This is a sporadic problem and should occur only in a network-installation.
The online curves are ok.
Remedy: Check the server. If you are not shure, check the online-curves.
8.6 System diagnosis with Windows98/NT
Windows 98: Use the tab “System Information” under the Tab
“Start - Programs – Accessories – Tools”
Windows NT: Use the tab “Event Viewer” or “Windows NT Diagnostics” under Tab
“Start – Programs – Administrative Tools”