Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 80
Servicing Instructions 227 436 37 Rev. B V1.3
- Blood pressure display cut off
In the operating modes late potentials and ergometry the blood pressure display can be
cut off, especially when the diastolic value is a 3-figure number (only in the case of
monitors > 17" and VGA or 800 x 600 resolution).
Remedy: Select higher resolution (800 x 600 or 1024 x 768 or higher).
- No connection to ergometer
Stress test performed in German with EC 1200 and BD2 (BOSO), was correct. Language
option French selected and start: no command sent to ergometer. Command comes only
after calling up stress test a second time.
Remedy: After switching to a new language option terminate the program and restart.
- No connection to ergometer Ergoline 900
Remedy: Use of Version “752” or “M345” with OEM 4 Buttons or Version “236”/”436” in
Program 10 with original 25 Button Ergoline.
- No RAS connection with ELSA Modem
Pulse dailing is not supported from ELSA 33.6 TQV Modem
Remedy: Select Tone Dailing.
- Modem RAS connection is not started
In MUSE Settings of System Configuration of CardioSys is activated "Start Modem
connection before transfer", but the connection is not started. Please do not start
manually the Modem RAS connection, when you configure that the application should
start the connnection.
Remedy: Terminate the manually started Modem RAS connection.
- Not enough memory space when compromizing exeminations
When compromizing examinations and using a Hard Disk >4.3GB the following message
will occur that less than 15% of storage medium is free.
Remedy: Set the percentage of storage medium in CardioSys
Tab “System Configuration”, Button “Database” to 1 %
- Wrong Start of Right Heart Cathederization
After installing Microlab and reboot again you should wait until the pc-card is loaded from
a DOS-window, before starting Microlab.
Remedy: If you don’t wait and you start Microlab before the pc-card is loaded, the
Right heart cathederiderization cannot be startet. In this case you must
Reboot the system again.