Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 77

Servicing Instructions 227 436 37 Rev. B V1.3

[15012] Error during CORINA downloading

see error message [6555]

[15013] CORINA not connected or not switched on!

see error message [6100]

[15076] Function disabled as the examination was not assigned to a patient

[15111] Access to examination in the network denied

8.4.13 Error messages [16xxx]: Tonoport

[16807] Error 01: Memory is full

[16808] Error 02: Battery is empty

[16809] Error 03: Measuring period has elapsed

[16810] Error 05: Micro withdrawn during blood pressure measurement

[16811] Error 06: Pumping period has elapsed

[16812] Error 07: Pump should not pump higher

[16813] Error 08: 200 blood pressure measurements taken

[16814] Error 10: Internal error in diastole identification

[16815] Error 14: Diastole under 50 mmHg

[16816] Error 15: Patient movement artefact during diastole identification

[16817] Error 18: Systole outside measurement range

[16818] Error 19: Diastole outside measurement range

[16819] Error 21: Difference systole - diastole too small (10 mmHg)

[16820] Error 22: Too many patient movement artefacts during systole identification

[16821] Error 24: Systole identification period has elapsed

[16822] Error 26: Systole under 70 mmHg

[16823] Error 27: Systole over 250 mmHg

[16824] Error 29: Too few oscillations identified (apply cuff more tightly)

8.4.14 Error messages [17xxx]: Right-heart catheterization

[17619] TramNet connection defective

Connector cable has become disconnected or is defective, Tram-Rac not

switched on

[17620] Communication error to the RAC

Connector cable defective, malfunction on interface card or Tram-Rac

[17621] Module sequence incorrect

Modules have been inserted into the Tram-Rac in the incorrect sequence

[17622] Module missing or pulled out

[17623] Sensor missing

Sensor not connected to the module (all modules).

[17624] Check sensor

[17625] Thermistor for injectate defective

only for HMV

[17626] Baseline outside limits

PRESS only; zero offset too large