Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 61
Servicing Instructions 227 436 37 Rev. B V1.3
6.1.10 Connector cable Tram-Rac (MicroLab only)
223 398 01 Connector cable
217 332 01 Dongle Tram-Rac
6.1.11 Connecting an IPS (Interruption-free Power Supply)
The following IPS can be recommended: CardioSys: ESV5+ from MGE
MicroLab: ESV8+ from MGE
The IPS must be located outside the patient area. The IPS should be connected up to a
permanent power supply. When CardioSys/MicroLab is switched off at the power socket
the IPS will always discharge and may not reach its maximum capacity. Moreover, the
printer should not be linked up via the IPS as this may lead the IPS becoming
overloaded.
6.2 Software options
6.2.1 Application software
455 022 01 Basic software
455 023 01 Resting ECG measurement
455 024 01 Resting ECG interpretation
455 025 01 Ergometry S, 3-channel ECG
455 026 01 Ergometry AT
455 027 01 Online ECG storage, data management, data compression
455 029 01 Ergometry monitoring
455 030 01 Storage in the network
455 032 01 Ergometry expert mode
455 033 01 Ergometry direct printout
455 034 01 Request management
455 035 01 Late potential analysis
455 039 01 Review Manager
455 040 01 ECG History
455 041 01 Cardio-Mailbox