Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 47
Servicing Instructions 227 436 37 Rev. B V1.3
contained inside of the AR200P, and will not be changed by the
ARUPDATE utility. Click the "OK" button to dismiss the "About"
dialog box, and click "Exit" on the menu bar to end ARDEMO.
IMPORTANT: ARUPDATE IS AN MSDOS PROGRAM AND WILL NOT RUN UNDER
WINDOWS NT. YOU MUST USE MSDOS OR WINDOWS 3.1.
MAKE SURE THAT NO OTHER PROGRAMS ARE RUNNING ON YOUR
COMPUTER BEFORE YOU START ARUPDATE.
To run ARUPDATE under MSDOS, insert the AR200P software
distribution disk into a floppy drive and change to the root
directory of that drive. Type ARUPDATE (see the Windows 3.1
instructions below if the AR200P is connected to LPT2 or LPT3).
To run ARUPDATE under Windows 3.1, insert the AR200P floppy disk
in a drive and select the "Run..." item from the "File" menu of
the Windows 3.1 program manager. Type "x:ARUPDATE" (where x is
the letter of the drive). This assumes that the AR200P is
connected to LPT1. If it is hooked up to LPT2, type "x:ARUPDATE
/LPT2" instead, or "x:ARUPDATE /LPT3" if connected to LPT3.
ARUPDATE will determine if it can upgrade your recorder's
program, and if so, will ask if you want to replace the current
version with the one on the ARUPDATE disk. If you press any key
other than "Y," ARUPDATE will abort leaving the original program
unchanged.
ARUPDATE performs several system checks before actually changing
the contents of flash memory. If it detects a problem, it will
display an appropriate error message and abort, leaving the
recorder program unchanged. In the unlikely event that ARUPDATE
fails during the erasure or reprogramming phases of the update
process, it must be rerun to a successful completion before the
AR200P can be used. Recheck the cable connections, turn the
power off for 15 seconds, then back on, and retry ARUPDATE.
ARUPDATE FILES IN THE ROOT DIRECTORY OF THE AR200P SOFTWARE DISK
ARUPDATE.EXE Run this program to update flash memory.
ARUPDATE.PIF Windows 3.1 program information file for above.
FLASHCOM.BIC Auxiliary file needed by ARUPDATE.EXE
ARUPDATE.TXT This file.
BCODE###.FPG New file to be programmed into recorder flash
memory. (The version number of the code appears
in place of ###.)