Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 24
Servicing Instructions 227 436 37 Rev. B V1.3
* Patient cable
Connect up patient cable to CORINA (patient input).
Put ferrite near the connector of this cable.
Important: the patient cable may only be connected up to this interface.
* Printer (optional)
Place printer on the shelf. Connect the printer cable up to the printer and printer port
(LPT1). Connect the additional non-fused earth conductor connector up to the printer
and the system cart (see figure in Section 4 Adaptor connector configuration). Connect
printer power cord up to a separate power cord connector socket (Important! Not to the
system cart).
Important: Only printers modified by Marquette Hellige (with additional non-fused
earth conductor connected) are to be placed on the system cart, when in patient
use.
5.1.1 Microlab: Assembling the Tram-Rac, possible structural
modifications
The CardioSys User’s Manual describes how to assemble the Tram-Rac. Nevertheless,
here are a few addition comments.
A description of how to assemble the Tram-Rac and the connection to the PC and the
dongle are described in the CardioSys User’s Manual.
Retaining bow for the power cord: strain relief on the power cord is removed by the
Tram-Rac. The retaining bow for the power cord is attached by the same screw as on the
Tram-Rac after the power cord has been threaded through.
The Tram-Rac can now be mounted to the two sides of the cart. When doing this make
sure that the power cord and the connection cable are laid in the corresponding side
member.
Microlab is normally meant for use whilst the operator is standing up. By dismantling the
keyboard drawer it can be modified for operation in the sitting position.
5.2 Installation of the software
After Software installation please reboot the system!