Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 11
Servicing Instructions 227 436 37 Rev. B V1.3
After switching the Power on/off switch to ON, the STANDBY SWITCH near the disk
drive must be used to turn the PC-power supply from standby mode to working mode
and back.
3.2.3 CPU card
CPU Pentium II / 350
cache 512KB
memory 64 MB DIMM PC-100
interfaces HDD/FDD EIDE interface, keyboard & mouse interface,
2 serial interfaces, parallel port interface, USB port
bus 2 x ISA, 4 x PCI, 1 x AGP
3.2.4 SVGA card
resolution: 1024x768 for 65536 colors (default configuration)
memory: 8MB SGRAM
bus: AGP
output: 15-pin D-SUB connector (shrinked type)
3.2.5 Interface card
This card has the following interfaces:
* two serial interfaces
* one parallel interface
The serial interfaces can both be busy with different interrupts (IRQ 1 to 15) to enable all
interfaces to be used simultaneously.
3.2.6 Hard disk
There is an internal 3½” hard disk.
* interface: EIDE
* capacity: min. 3,2 GB
3.2.7 Floppy
There is an internal 3½” (1.44 MB) floppy.