Operating instructions

Marquette Hellige GmbH CardioSys / MicroLab V4.X Page 107
Servicing Instructions 227 436 37 Rev. B V1.3
Standard setting ex-factory:
Figure 1: Jumperblock
INSTALLATION:
The D-SUB plugs and sockets on the slot connector can be mounted in an unused
knock-out panel found on most cases, or alternatively, using the mounting brackets, into
any free expansion slot.
Now connect the ribbon slot connector to the corresponding socket on the board. Make
sure that the colour-marked wire is connected to the side of the board marked "1". The
ETC-9081 can then be inserted into any free 16-Bit expansion slot.
Figure 2: Connecting the ribbon slot connectors