Installation guide

15
SCSI Card 2906 User’s Reference
Configuring the SCSI Card
2906 with SCSI
Select
SCSI
Select
(included on a separate diskette in your package) enables
you to change SCSI
Select
settings without opening the computer or
handling the card. SCSI
Select
also enables you to low-level format or
verify the disk media of your SCSI hard disk drives. Table 2 lists the
available and default settings for each SCSI
Select
option.
Note:
The default settings are appropriate for most systems.
Run SCSI
Select
if you need to change or view current set-
tings, or, if you would like to run the SCSI disk utilities. See
the descriptions of each option in
SCSI Bus Interface Defini-
tions
on page 17.
Table 2. SCSI Select Settings
SCSI
Select
Option Available Settings Default
Setting
SCSI Bus Interface
Definitions:
Host Adapter SCSI ID 0-7 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination Automatic,
Enabled, Disabled
Automatic
Additional Options
SCSI Device Configuration:
Initiate Sync Negotiation Yes, No Yes
(Enabled)
Maximum Sync Transfer Rate 10.0, 8.0, 6.7, 5.0 10.0
Enable Disconnection Yes, No Yes
(Enabled)
Advanced Configuration
Options:
Plug-and-Play SCAM Support Enabled, Disabled Disabled