Installation guide

12
SCSI Card 2906 User’s Reference
How do I use the Hardware Conflict Troubleshooter in Windows 95/98?
1
Click the
Start
button, then click
Help
.
2
From the
Contents
tab, double-click
Troubleshooting
.
3
Double-click
If you have a hardware conflict.
4
Follow the step-by-step instructions in the Windows Help
window.
Common Error Messages
“Device connected, but not ready”
The SCSI card received no answer when it requested data from an
installed SCSI device.
■
Make sure the drive is set to spin up when the power is
switched on. (See the documentation for the device.) If you still
have problems, you may have a bad drive. If you can still
access your computer, follow these steps:
a
Click the
Start
button, point to
Programs
,
Accessories
,
Sys-
tem To o ls
, and then click
ScanDisk
.
b
Click
Start
and then wait a few moments for results.
“Time-out failure during...”
An unexpected time-out occurred.
■
Verify that the SCSI bus is properly terminated.
■
Verify that all cables are properly connected.
■
Disconnect the SCSI cables from the SCSI card and then start
the computer. If the computer successfully restarts, one of the
SCSI devices, cable, or terminator may be defective.