Installation guide

1
In this Guide...
This Hardware Installation Guide explains how to set up the 4-bay
hot-swappable drive chassis included in the Adaptec
®
2410SA
Enclosure kit. It also describes how to install and hot-swap hard
disk drives.
Before You Begin
Ensure you have these items from the Adaptec 2410SA Enclosure
kit before beginning the installation:
■ Adaptec 2410SA Enclosure drive chassis
■ Four drive carriers
■ Four SATA cables
■ SATA LED cable
■ Bag of screws and labels
You will also need a screwdriver during installation.
Before You Begin 1
Installing the Drive Carriers 2
Labelling the Drive Carriers 3
About the Drive LEDs 3
Installing the Drive Chassis 3
Hot-swapping Disk Drives 6
Technical Specifications 7
2410SA Enclosure Kit HIG.fm Page 1 Thursday, October 23, 2003 1:20 PM