Product manual

30
Adding to SCO UNIX 3.2V4.2 or OpenServer 5
When adding an Adaptec controller to an existing SCO UNIX
configuration, perform the following steps.
1
Install the Adaptec controller.
2
Boot SCO UNIX.
3
After SCO UNIX has booted, place the Adaptec SCO driver disk in
the floppy drive.
4
Run the
installpkg
utility.
5
SCO UNIX will read the disk and prompt you to enter the
package name to be installed. Enter dpti4 for SCO UNIX 3.2V4.2
or ODT 3.0, and
dpti5
for SCO OpenServer 5.
6
Rebuild the kernel after the package is installed.
7
Shutdown and reboot the system to install the new kernel and add
devices on the controller.
SCO UNIX Ware 7
1
Install the Adaptec controllers and storage devices. For more
information, see the Installation Guide for your controller.
2
Obtain the latest I
2
O supplement for UnixWare 7 from SCO (it
should be
PTF7067E
or higher).